Installation test drive:

1. The stone production line equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.

2. When installing, pay attention to the verticality between the main body and the level.

3. After installation, check whether the bolts of various parts are loose and whether the main engine compartment door is tightened. If so, please tighten it.

4. Configure the power cord and control switch according to the power of the stone production line equipment.

5. After the inspection, carry out the no-load test run, and the test run is normal and the production can be carried out.

Maintenance points:

1. The shaft bears the full load of the negative machine, so good lubrication has a great relationship with the life of the bearing, which directly affects the service life and operation rate of the machine. Therefore, the injected lubricating oil must be clean and the seal must be good. Main oil filling place (1) Rotary bearing (2) Roll bearing (3) All gears (4) Active bearing and sliding plane.

2. The newly installed tires are prone to loosening and must be checked frequently.

3. Pay attention to whether the work of each part of the stone production line is normal.

4. Pay attention to check the wear degree of the wear-resistant parts, and pay attention to replacing the worn parts at any time.

5. On the bottom frame plane of the movable device, dust and other objects should be removed to prevent the movable bearing from moving on the bottom frame when the machine encounters materials that cannot be broken, resulting in serious accidents.

6. If the bearing oil temperature rises, stop immediately to check the cause and eliminate it.

7. If there is an impact sound when the rotating gear is running, stop it immediately to check and eliminate the fault.

The above information is provided by the aggregate line equipment. For more details, please visit www.ywjx.net